HID conversion kit(H1.H3.H4.H7.H8.H9.H11.H13.9005.9006.etc)
Color:3k to 30k or aboved
Main Technical Parameter:
HID lamp technical parameter:
Power
35W
Input Voltage
9V-16V
Standard Input Current
3.2A
Normal Operating Voltage
80V
Luminous flux
>3000lm
Color temperature
3000K,4300K,5000K,6000K,8000K,10000K,12000K
Lifetime
3000h
Ballast technical parameter:
Standard Input Voltage: 13.2V
Output power: 35W norm.
Voltage Accommodation Range: 9~16V
Electric Efficency: >85%
Standard Input Current: 3.2A
Maximum Input Current: 8A
Lifetime: >3000hrs
Momentary Maximum Ignition Voltage: 23KV
Ambient Temperature Range: -40~+105
Features of Xenon HID convertion kit:
6) HID conversion kit Bulb size:
H1.H3.H4-1.H4-2.H4-3.H4-4. H7.H8.H9.H10.H11.H13-1.H13-2.H13-3.H13-4.
9004-1/9004-2/9004-3/9004-4/9005/9006/9007-1/9007-2/9007-3/9007-4/D2C(D2R/S)/880/881.
7) Color temperature:
3,000K/4,300K/5,000K/6,000K/8,000K/10,000K/12,000K.or above.
We also carry extreme colors, Deep Blue/Purple/Green/Pink/Yellow.
Note: Our fraction defective is lower than 2%. If you purchase 100 sets at a time, 2 sets will be presented free.
Product and Accessories List:
· Two Xenon HID Bulbs ( Buyer chooses Bulb type and Color Temperature)
· Two Ballasts
· Two supports of Ballast
· Eight fixation buckles of wire
· Two screws
· One Operation Instruction
THE PROCESS FOR INSTALLATION:
1. Separate the headlamps (right&left)from your car after opening your car bonnet,if there is enough space for car bonnet,if there is enoughj space for exchange ,it is not needed to separate the headlamps from your car.
2. Open the rear cover of the headlamp and pull the installed halogen lamp out.
3. Drill a hole in the middle if the rear cover of the headlamp with a 21mm hole cutter.
4. Take out the plastic cap of the HID bulb.
5. Put the HID lamp into the headlamp unit.
6. Connecting the wires-referring to the wiring diagram in the guide book.
7. Close the cap of the headlamp after fitting the rubber barking attached to the bulbs wire into 9 the units cover.
8. Stick te ballast on the nearest place from the headlamp in the engine room firmly by using double-faced tape,cable tie and etc.
9. Connect the wire of the ballast with the wire of bulb.
10. Test whether or not the headlamps work properly.
Related Product Tags:
hie ballast , Ballast , electronic ballast , electronic ballasts , E1 Ballast , philips electronic ballast , auto ballast , ballasts , thinner ballast , canbus ballast , Bulb And Ballast , Bulb B Ballast , rear beam , longitudinal beam , v beam , sunbeam , single beam , beam carrier