Street Address: The East Of Dongyue Street
City: Tai'an
Province: Shandong
Country/Region: China
and so on
PJ-40 injector tester The tester is used to adjust and test the fuel diesel engine injectors injecting pressureatomizing quality jnjecting angle and the seal of needle valve. At first: fix the injector onto the middle of the bear pressure tie tightly with the clamp handle, or use the high pressure pipe connect to the middle of the behind bear pressure tie. Second: do the test of pumping oil infering to the pressure of injector which to be tested, adjust the adjustion blot on the upside of the injector, after the oil is pumped , observe the atomizing quality and test the injecting angle. 2test the atomizing quality observe the status of atomizing quality: the atomizing granule should be small and equably. No big oil trickle saw with eyes .the oil is to be injected to a absorbing oil paper which has no big oil dots on it. injecting fuel shoule be quickly, there is no phenomenon of oil drop or oil droping after injecting , the injecting taper angle should be within the prescribed range.
PJ-40 injector tester The tester is used to adjust and test the fuel diesel engine injectors injecting pressureatomizing quality jnjecting angle and the seal of needle valve.
At first: fix the injector onto the middle of the bear pressure tie tightly with the clamp handle, or use the high pressure pipe connect to the middle of the behind bear pressure tie. Second: do the test of pumping oil infering to the pressure of injector which to be tested, adjust the adjustion blot on the upside of the injector, after the oil is pumped , observe the atomizing quality and test the injecting angle.
2test the atomizing quality observe the status of atomizing quality: the atomizing granule should be small and equably. No big oil trickle saw with eyes .the oil is to be injected to a absorbing oil paper which has no big oil dots on it. injecting fuel shoule be quickly, there is no phenomenon of oil drop or oil droping after injecting , the injecting taper angle should be within the prescribed range.