Product Attribute:
Length:28cm
Width:25cm
Height:20cm
model:INTL-XZC541
groove:6PK
voltage:12V
car made:or Chevrolet Colorado GMC Canyon Hummer H3 H3T Isuzu I-350 I-370
parts number:447220-4892 4472204892 15203089 15223664 89022562 15268654 25891795
compressor type:DENSO 10S17C
pulley diameter:140mm
Applicationt:
or Chevrolet Colorado, GMC Canyon Hummer H3 H3T Isuzu I-350 I-370
Production Description:
Our factory can produce many kinds of auto Air Conditioner Compressors with good quality and one year quality warrantee.
10S17C Compressor For Chevrolet Colorado/GMC Canyon/Hummer H3 H3T/Isuzu I-350, And I-370.
Specification:
Model number: INTL-XZC541
Car name: for Chevrolet GMC ISUZU HUMMER
Year Model: 2004-2011
Compressor Type: Denso 10S17C
Grooves: PV6
Volt: 12V
Clutch DIA:140mm
Special Notes:
ACDelco:15-21194Denso:447220-48924472204892Four Seasons67337General Motors:1520308915223664890225621526865425891795
Details
2004-2011 for Chevrolet Colorado
2004 Chevrolet Colorado
2005 Chevrolet Colorado
2006 Chevrolet Colorado
2007 Chevrolet Colorado
2008 Chevrolet Colorado
2009 Chevrolet Colorado
2010 Chevrolet Colorado
2011 Chevrolet Colorado
2004-2011 GMC Canyon
2004 GMC Canyon
2005 GMC Canyon
2006 GMC Canyon
2007 GMC Canyon
2008 GMC Canyon
2009 GMC Canyon
2010 GMC Canyon
2011 GMC Canyon
2006 for Isuzu i-350
2007-2008 for Isuzu i-370
2007 Isuzu i-370
2008 Isuzu i-370
2006-2010 for Hummer H3
2006 Hummer H3
2007 Hummer H3
2008 Hummer H3
2009 Hummer H3
2010 Hummer H3
2009 for Hummer H3T
Basic Requirements when servicing an A/C system:
1, The Accumulator or Filter Drier should always be replaced when the Air Conditioning System is opened. For warranty Purposes buyer must show evidence of receiver/drier replacement. In some vehicles the drier comes attached to the condenser so it must replaced as well
2. A/C system must be clean and free of debris and contaminants. In most cases components can be flushed; however in some instances it may be necessary to replace the condenser or other items.
3. Orifice tube must be replaced; expansion valve must be inspected and replaced if dirty or defective.
4. Correct amount and type of oil must be used. Please refer to the OE manufacturer for this information.
5. Prior to refrigerant charging, full vacuum must be done for a minimum of 45 minutes. In humid climates or during cooler days, this time should be increased to effectively remove air and boil off moisture.
6. The Orifice Tube, if equipped, should always be replaced and the Expansion Valve, if equipped, should at least be inspected for proper operation if not replaced