Applicationt:
opel
Production Description:
OP-COM V1.39 means it will:
· Support 2009 Models
· Support Saab 9-5 and Saab 9-3 CAN
· Covers almost all Opel cars from 1992 - 2009, even new cars with CAN-BUS based diagnostic, such as Vectra-C, Astra-H, Zafira-B
OP-COM is a PC based Opel diagnostic program. This interface can read out and clear fault
codes, shows you live data, lets you to perform output test, and supports remote, and
key programming.
The program supports many control units, such as:
· Engine
· Automatic Transmission
· ABS
· Airbag
· Engine Cooling module
· Instrument Cluster
· Electronic Climate Control
· Body Control Unit
· Many others..........
Since Opel uses many pin in the OBD connector, the diagnostic interface works as a
multiplexer, and selects the appropriate pin for communication.
PIN3, PIN7, PIN8, PIN12 = Serial Link (ISO9141, KW81, KW82, KWP2000)
PIN6-PIN14 |
HSCAN - Dual-wire, High Speed CAN-BUS, 500 kbps |
|
PIN3-PIN11 |
MSCAN - Dual-wire, Medium Speed CAN-BUS, 95 kbps |
|
PIN1 |
SWCAN - Single-wire, Low Speed CAN-BUS, 33.3 kbps |
Fault codes will be shown with all available information:
· Full fault code text description
· Full status information (Present, Not present, Intermittent)
· You can print out, save, or copy the fault codes to any other application.
From the fault codes window, you can go directly to the measuring blocks window.
The program shows you measuring block information on many control module, you can
choose anything from the list on your own. The program is capable of showing 8 measuring
block parameter simultaneously. The sample rate is depends mostly on the communication
protocol. For example, older system, like Omega-B X 25 DT Engine (ISO-9141-2) can be very slow, during communication, while newer Multec, or Bosch units are faster
(using KWP-2000), and the newest CAN based control units are very fast!
You will get a feedback on the state of the