Home » Showroom » » Products » Other Parts » BMW Seat Occupancy Sensor Emulator

BMW Seat Occupancy Sensor Emulator

BMW Seat Occupancy Sensor Emulator

Application:  Changfeng, Chrysler, ...

Market Type:  After Market

Product Attribute:

Applicationt: 

Changfeng, Chrysler, Daihatsu, DADI Auto

Production Description:


Descriptions for BMW EWS2 EWS3.2 Emulator
Installation:

1. Remove original EWS2 control unit, find +12v ACC, GND, K-line wires, attach emulator. Emulator must be in service mode: JUMPER 1shorted.

2. Connect ANY K-line diagnostic adapter to vehicle diagnostic connector and launch Emulator Configuration Utility:
3. Choose COM port, write in desired ISN number, press button Store.

4. For some ECUs, it is possible to read ISN number directly from engine control unit. In this case, select option"ECU xxxxx", press Read. Software will try to read ISN. If successful, choose option"EWS emulator" and press button Storeto save ISN number into emulator.

5. Disconnect emulator from K-line, remove JUMPER 1 and connect K output from emulator to DME (DDE) EWS line.

6. Don't forget to short two starter relay wires (EWS connector)!

7. Car is ready to start.



What is immo emulator used for?
Immo emulator replace damaged immobilizers or car keys.
In case of EWS3.2 similar procedure is used, only difference is that it is NOT connected directly to diagnostic K-line.

There are NO any counters or car starts limited. You can change and store new ISN without any limitations.

Emulator is shipped with JUMPER 1shorted. For testing purposes, ISN 0579 is stored by default.

Send your message to this supplier

Enter between 20 to 3,000 characters, English only.
http://en.gasgoo.com/new/common/contactsupplier.aspx?type=4&id=1089511