Applicationt:
General
Production Description:
The function of bi-xenon projector 1 The projector can install AFS and ALS 2 The standardization, bi-xenon projector can self-super regulation the far sight and near sight, the standard has matched up E-mark and AUSI. The light through the lens, the sight shape is very balanced, and the distribution of light is equality. While switch the near sight, the light still gentle which would not offense approaching driver, while in far sight, the focus can shoot further and the light is much clearer. 3 concentrations, bi-xenon projector accompany with HID xenon lamp. While people use HID xenon lamp in order to brighter light, but too much high color will glare eyes which result in difficult to exam the condition the road. While use projector, no matter how high the color temperature you use, the light is soft and bright. Specially, in fogging and raining weather, the light in moisture and mist will have refractive dispersion, while use bi-xenon projector, the light still in focus, the driver can be reconciled to driving. 4 attractions it is very prevailing to modify head lamp with angle eyes and projector. For formerly, only BMW and AUDI have such appearance, now any car has chance to become attractive. The modification step of projector 1 find out the focus and horizontal plane, use coordinate to set up focus and horizontal plane, because the horizontal plane is the opaque border 2 put the head lamp group into a box, had leave a hole before seal the box, then use heat stylus face of the hole to work for 15min (Note: the heat stylus is not allowed pointing at the head lamp) 3 while plastic become soft, to separate the cover and group (Note: this time the head lamp group is very hot, the operator is suggested to use rag or other tools to separate the group) 4To fix the projector on reflective cup (Note: the focus and horizontal plane of projector now must symmetry to the focus and horizontal plane of reflective cup) 5 after the above steps, to adjust the cover and group matching and using the glue to stick two part. The put the head lamp group into the box for heating 8 min, finally, to press the group turning into previous condition, then clasp the claspers. 6 To exam is there anything in wrong, if everything is in good condition, the head lamp group is tested by indicated line. If the focus of right and left of head lamp group are balance which means the successful modification