AN9 Sensors
Thin, programmable, non-contact magnetic position sensors capable of continuous rotation with dual outputs
AN9 Series Angle Position Sensors Description
The AN9 Series sensors are non-contact, intrinsically linear angle position sensors with two independent outputs. The sensors operate through the use of Hall Effect technology with magnetic fields generated by permanent magnets. They provide a linear change in voltage output (ratiometric to the input voltage) corresponding to an angular rotation of the input shaft.
AN9 Series Angle Position Sensors Features
Angular position sensor with high tolerance for misalignment
Non-contact angular position sensing and full 360° rotation
Dual independent (fully redundant) outputs assure high reliability
Custom programming available for: angle range, slope, PWM output, custom magnets contact factory
No mechanical interface means no parts to wear out or jam
Comes with 18 AWG 305 mm (12) wire leads
RoHS Compliant
IP67
Maximum air gap of 5.5 mm (0.22)*
AN9 Series Angle Position Sensors Typical Applications
Implement (fork lift, agricultural trailer hitch, etc.) position sensing
Steer, throttle by wire
Gear selection
Zero-contact encoder alternative
Replacement for smart bearings
Outboard trim sensing
AN9 Series Angle Position Sensors Environmental Specifications
Vibration | 15g sinusoidal, 9.26g RMS axial; 40 Hz 2 kHz all 3 axes |
Operating Temperature | -40 °C to 125 °C (-40 °F to 257 °F) |
Storage Temperature | -40 °C to 150 °C (-40 °F to 302 °F) |
Ingress Protection | IP67 |
Input Voltage | 5.0 VDC ± 10% |
Output Voltage | 10% to 90% of input (see graph for voltage vs. rotation angle characteristics) |
Input Current | 14 mA typ., 16 mA max. |
Output Current | -8 mA to 8 mA |
Output Accuracy | ±3.5% |
Output Linearity | ±3.5% |
Maximum Overvoltage | 16 VDC |
Absolute Max. Output Current | ±30 mA |
Output Type | Analog (PWM available) |
Housing Material | Glass Reinforced Plastic |
Mechanical Travel | 0° to 360° (continuous) |
Maximum Air Gap* *with AS500106 magnet carrier |
5.5 mm (0.22") |
Maximum Center-To Center Offset | 2 mm radial (magnet to center) |
Part Number (Sensor) | Sensing Range | Wires |
AN920031 | 180° | 18 AWG x 305 mm (12") |
AN920032 | 360° | 18 AWG x 305 mm (12") |
AN920035 | 45° | 18 AWG x 305 mm (12") |
AN920036 | 90° | 18 AWG x 305 mm (12") |
Related Product Tags:
camshaft position sensor , New Camshaft Position Sensor , CMPS Camshaft Position Sensor , type camshaft position sensor , ckp sensor , VW Crankshaft Position Sensor , Peugeot Crankshaft Position Sensor , Renault Crankshaft Position Sensor , Hyundai Crankshaft Position Sensor , Nissan Crankshaft Position Sensor , Fiat Crankshaft Position Sensor , crankshaft position sensor , Auto Position Sensor , Truck Position Sensor , Car Position Sensor , Good Position Sensor , Angle and Position Sensor , Camshaft and Position Sensor