Quick Details

• Supply Ability:

  10000 Piece/Pieces per Week

• Packing:

  Inner packing :white box ,Out packing: Carton box with kraft paper

• Delivery Port:

  SHANGHAI / NINGBO

• OE Experience:

  No

Product Name:Ford9230065606 Ignition Distributor

Ford9230065606 Ignition Distributor

Application

all

Product Description:

DETAIL INFORMATION

IGNITION DISTRIBUTOR INSTALLATION

1.  Disconnect the wire harness from the distributor cap. Remove the cap from the distributor housing.

2.  Install the distributor gasket over the gear, and up to the distributor collar. A small amount of  

     gasket adhesive will help to hold the gasket in place.

3.  Luricate the distributor gear with engine oil.

4.  Turn the distributor shaft until the rotor is in the same position that was noted with the old distributor.

5.  Place the distributor into the engine. As the distributor drops down, the rotor will turn as it engages  

     with the camshaft gear. Adjust for this rotation by turning the rotor a few degrees prior to the gear

     engagement. Several attempts may be necessary to achieve the proper rotor position. The distributor  

     collar should sit completely flat on the intake manifold.

6. Turn the distributor housing until the vacuum advance canister points in the same direction as the  

    original.

7. Install the distributor, hold down and tighten the hold down bolt slightly.Once the ignition timing is

    adjusted the hold down bolt should be tightened completely.

8. Install the new distributor cap.

9. Starting with the number one spark plug wire, move the spark plug wires from the original distributor

    cap to the Flame-Thrower cap one by one.

10. Connect the wire harness and vehicle wiring harness into the distributor cap.

11. If a tachometer is used, connect the tachometer wire into the position marked TACH on the distributor

      cap.

12. Re-connect the battery.

13. Plug the vacuum hose that attaches to the vacuum advance canister

14. Check to insure that all spark plug wires are secure and in the correct place.

15. Start the engine, and check the base timing.

16. Check the vehicle manufacture specifications for the correct timing. Rotate the distributor housing to

      achieve the indicated timing specification.

17. Once the timing is properly adjusted, turn the ignition switch off and tighten the distributor hold down.

18. Re-attach the vacuum hose to the vacuum advance canister.

PRODUCT PHOTO

GOOD PACKING

FACTORY FACILITY

Established in 2002, Ningbo Jingdu Auto Parts Co., Ltd. is a Sino-Malaysian joint venture. Our production base is located in Wuxiang Town Industrial Zone, Yinzhou District, Ningbo City. Our company specializes in developing and producing automotive igniti[Read More]

Company Profile:

• Main Product:

  Distributor Assy, Distributor Cap, Distributor Rotor

• Business Type:

  Others

Factory Profile:

• Number of Employees:

  51 - 100 People